Alvin WTB48 조립 지침 - 페이지 2
{카테고리_이름} Alvin WTB48에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Alvin WTB48 2 페이지. Titan drafting tables
페이지 인쇄
To Attach Tabletop to Base Frame
This base can be used with 42", 48", or 60" wide top.
Inspect tabletop carefully and choose which side you
10
want facing up for use. This side should be placed
face-down on a carpeted or otherwise protected floor to
avoid scratches.
Carefully turn base frame assembly upside down and
11
place on tabletop. This may require two people.
Position base assembly so that front hinges are 1½"
12
from the front edge of the tabletop, as shown in diagram.
Hinges should also be centered evenly between left and
right sides of tabletop.
Adjust and position rear mounting brackets so they are
13
19½" from the front edge of the table top and centered
evenly between left and right sides, as shown in diagram.
Brackets should sit flush on the tabletop surface with the
rods facing straight up and down.
Mark locations of all 12 holes with a dark pencil or
14
marker and then use an awl or drill with
make starter holes. Use care not to drill all the way
through the tabletop.
Attach front hinges and rear brackets to tabletop using
15
I
¾" Phillips screws (
). Tighten securely but use care not
to over tighten and strip.
©2008 Alvin & CompAny, inC. • P.O. Box 188, Windsor, CT 06095-0722
Phone: 860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896
19½"
⁄
" bit to
1
16
1½"
Front Edge
www.alvinco.com
19½"
1½"
LIT-A8156 7/08