Akron 3462 설치, 운영 및 유지보수 지침 - 페이지 3

{카테고리_이름} Akron 3462에 대한 설치, 운영 및 유지보수 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Akron 3462 18 페이지. Forestry bumper monitor
Akron 3462에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)

페이지 인쇄

INSTALLATION, OPERATING and MAINTENANCE INSTRUCTIONS

The following is intended to provide the basic instructions for installation, operating and maintenance of

the 3462 forestry Bumper Monitor .

PRODUCT RATINGS

Maximum motor current draw:

12 volt versions

50 amps each for elevation and rotation motors (Locked rotor current)

24 volt versions 25 amps each for elevation and rotation motors (Locked rotor current)

Normal operating current (depending on operating conditions - pressure, flow, etc . ) :

12 volt versions

3 - 10 amps each for elevation and rotation motors

24 volt versions

Minimum Voltage: (Truck engine must be operating for proper voltage requirement.)

All 12 volt motors: 11 . 5 volts while operating

All 24 volt motors: 23 volts while operating

Mass: 23 lbs . (10 . 4 kg) with out nozzle or quick disconnect base

Maximum Flow: 300 GPM (1135 lpm)

Maximum Pressure: 200 PSI (14 bar)

Noise Emission: 94 Db@ 1m with Maximum Flow

PRODUCT WARNINGS

WARNING:

The maximum flow of the Bumper Monitor is 300 GPM . The center of the waterway outlet is 13

inches from the bottom of the inlet . Ensure these values and an appropriate safety factor is used to de-

termine a proper support structure .

WARNING:

Aim the Bumper Monitor in a safe direction before pumping water through it .

WARNING:

The Bumper Monitor uses current limiting for both the monitor and nozzle stops . Use only appropriate

Akron Brass nozzles .

WARNING:

Do not use the electric controls when the override cranks are being used or are in position for use .

WARNING:

If any tags or bands are worn or damaged and cannot be easily read, they should be replaced .

WARNING:

Disconnect power and disable flow before maintenance .

WARNING:

Keep all personnel out of the Danger Zone (in front of the outlet of the monitor) when the water

source is attached . Dangerous flow velocities can cause serious injury .

STYLE 3462 FORESTRY BUMPER MONITOR

3 . 0 amps for nozzle pattern motor

1 . 5 amps for nozzle pattern motor

0 . 7 amps for nozzle pattern motor

2 - 5 amps each for elevation and rotation motors

0 . 4 amps for nozzle pattern motor

122386