Ashly Protea NE4250 운영 매뉴얼 - 페이지 10

{카테고리_이름} Ashly Protea NE4250에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly Protea NE4250 16 페이지. Network enabled multi-channel power amplifiers
Ashly Protea NE4250에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 사양 시트 (2 페이지), 사양 (2 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (20 페이지), 운영 매뉴얼 (20 페이지)

페이지 인쇄

1. Amplifier Control Surface

Operating Manual - NE Multi Channel Power Amplifier

RD-8C or RW-8C Remote Control - The RD-8C and

RW-8C are remote level controllers which are connected to the

amplifier's Data Port, and are phantom powered from the ampli-

fier. They can only be used in NE amplifiers which have DSP

installed, and are used in conjunction with the "Remote Gain"

pluggable DSP tool placed in an input or output in software.

Maximum cable length is 1000 ft using #24 gauge twisted

pair. The RD-8C is a desktop controller, while the RW-8C is

electronically the same but mounts as a wall plate using a stan-

dard North American 4-gang electrical box and connects using

a Euroblock.. There are eight channels and a master, each with

a fader control and an on/off button. Note: Only one RD-8C

can be used per amplifier, and use of an RD-8C will exclude

the use of the data port for a WR-5. One or the other remote

control device may be connected, but not both

WR-5 Programmable Remote Con-

trol - The WR-5 is a programmable button

remote control which mounts into a standard

North America electrical wall box and con-

nects to an amplifier data port using four

conductor wire. Maximum cable length

is 1000 ft using #24 gauge twisted pair. A

decora cover plate (not included) can be

purchased at hardware stores to cover the

WR-5 electrical box and satisfy the aesthetic

needs of the installation. The WR-5 is phan-

tom powered from the amplifier. Up to four

different WR-5 remotes can be phantom

powered from one amplifer, and more can

be added by purchasing an Ashly RPS-18

remote power supply.

WR-5 buttons are programmed from Protea

number in its WR-5 device window. Each button has a status LED. Standard control functions include preset recall/scroll and

mute, and in amplifiers with DSP installed the functions also include gain control, zone source selection, individual channel and

matrix point level control. Note: To use the WR-5 as a remote level control, a (ne)WR-5 Remote Gain tool must be placed in

one of the DSP processing blocks of the channels(s) to be controlled. A windowed mylar pocket is available to insert custom

function button labels.

INA-1 Inline RS-232 Adapter - The amplifier Data Port uses a proprietary serial communications protocol which can

be converted to RS-232 by purchasing the Ashly INA-1 RS-232 adapter. This allows the use of custom designed third party

RS-232 controllers.

software after the WR-5 is wired to an amplifier and assigned a unique ID