Ashly MX-406 운영 매뉴얼 - 페이지 5

{카테고리_이름} Ashly MX-406에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly MX-406 12 페이지. Stereo microphone/line mixer
Ashly MX-406에 대해서도 마찬가지입니다: 운영 매뉴얼 (12 페이지), 기술 노트 및 사양 (2 페이지), 운영 매뉴얼 (12 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

capacity of the MX-406, the stereo line input can be used as

stacking inputs for supplementing the MX-406 with another

mixer, such as an Ashly LX-308 stereo line level mixer .

4.7 Aux Master Output

This control adjust the level of the aux master ¼"

jack output, which gets it's signal from the six aux level

controls on the input channels . It is used for an effects unit

send, or can drive a power amplifier for monitors or an extra

loudspeaker zone .

4.8 Main Outputs

These two controls determine the signal level to the

¼" jack left and right outputs . They are used to drive power

amplifiers for the main loudspeakers, or to connect to a stereo

recording device .

4.9 Mono/Phones Output

Thinner concentric knob adjusts the level of the

summed mono output . It is completely independent of the main

left and right master controls . In other words, changes to either

left or right output level will not affect the mono output level .

The outer concentric knob adjusts the level of the

stereo signal to the headphone jack . Headphones should have

an impedance of 600 ohms or greater, or signal distortion may

result .

Operating Manual - MX-406 Stereo Microphone/Line Mixer

used to indicate stereo output level in VU . 0 VU is equivalent

to +4 dBu (1 .228Vrms) .

0 VU and two red LED's indicate clipping . The clip LED's

turn on 3dB below actual clipping, detecting excessive signal

level on any critical audio path within the master section . If

all outputs are turned down and there is still clipping, then one

or more inputs must be turned down .

When the switch is pressed in, the LED is lit and +48VDC

is applied to all six mic inputs for use with condenser mi-

crophones . If there is a mix of both condenser and dynamic

microphones, the phantom power will not affect the operation

of the most dynamic mics .

4.10 Output Meters

A pair of peak reading 10 segment LED meters are

Green LED's are used below 0 VU, yellow above

4.11 Phantom Power LED

The phantom power switch is on the back panel .