Ashly XR-1001 운영 매뉴얼 - 페이지 10

{카테고리_이름} Ashly XR-1001에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly XR-1001 13 페이지. Electronic crossover
Ashly XR-1001에 대해서도 마찬가지입니다: 브로셔 (1 페이지), 운영 매뉴얼 (16 페이지), 기술 노트 및 사양 (2 페이지), 운영 매뉴얼 (8 페이지)

페이지 인쇄

Page - 10

Safety Instructions – 3

Introduction – 4

XR Crossovers – 5

Situation

No Output

Connectors & Cables–5

Physical Description – 6

Peak light flashes

Installation – 7

frequently

Typical Applications – 8

Troubleshooting - 10

Distorted sound

Dimensions - 10

Specifications - 11

Excessive hum or noise

Warranty - 12

Action

Check AC power - is LED indicator on? Check in/out connections, are they reversed? Are

you sure you have input signal?

The level is too high somewhere in the crossover. Try turning down individual output levels

and then the input until the peak LED stays off. If the peak LED continues to flash when all of

the crossover level controls are turned down, then the crossover is being fed excessively

high levels from a previous piece of equipment. Turn down your driving source.

Is the peak light flashing? If it is, an overload is occurring within the crossover, and may also

be occurring in other parts of the system. If the peak light is not flashing, the distortion is

occurring somewhere outside the crossover.

Hum will usually be caused by a "ground loop" between components. Try using the

suggested balanced input and output hookups if the other pieces of equipment used in

conjunction with your crossover have balanced inputs and outputs. Noise can be caused by

insufficient drive signal. Ashly crossovers provide the best noise and headroom performance

when the input signal is 0 to +4dBu level and power amplifier sensitivity is higher than 1 volt.

Unshielded cables, improperly wired connections, and cable with broken strands (shorts,

etc.) are the most common problems. Please properly maintain and inspect your wiring first.

Note: Unshielded cables, improperly wired connections, and cable with broken strands

(shorts, etc.) are the most common problems. Make sure you use good quality cable with

connectors soldered firmly on the correct pin. When in doubt, get in touch with your Ashly

dealer.

Operator Manual – XR Series Crossovers