ASI 0391-1AC 설치 및 유지 관리 매뉴얼 - 페이지 11

{카테고리_이름} ASI 0391-1AC에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASI 0391-1AC 16 페이지. Soap dispenser and remote control

BATTERY REPLACEMENT INFORMATION

Battery models only

When the batteries weaken, the red indicator light will blink at a

constant rate when the user's hands are within the sensor range. The

batteries must be replaced within two weeks.

To replace the batteries:

1. Carefully open the battery box, use Phillips drive #2 to remove cover

screws (Fig. 1&2, below)

2. Remove the old batteries from carrier tray (Fig. 3)

3. Replace the used batteries with new D batteries in same polarity

(Fig. 3)

NOTE: Do not mix used batteries with new ones.

4. Close the box and re-tighten the screws (Fig. 4) and reconnect battery cable.

Important: Spent batteries should not be discarded of with

normal household waste. Contact your local authority for

information on waste disposal and recycling.

MAINTENANCE

Care and cleaning of chrome and special finishes- see also PCM document.

DO NOT use steel wool or cleansing agents containing alcohol, acid,

abrasives, or the like. Use of any cleaning or maintenance products

containing these substances could damage the surface of the soap

dispenser. For surface cleaning use ONLY soap and water, then wipe dry

with a clean cloth or towel. When cleaning bathroom tiles or counters,

protect the soap dispenser from any splattering of harsh cleansers.

1408201627 Rev G

05 August 2015