ASI 0391-1AC 설치 및 유지 관리 매뉴얼 - 페이지 15

{카테고리_이름} ASI 0391-1AC에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASI 0391-1AC 16 페이지. Soap dispenser and remote control

OPERATION

If desired, use the remote control to adjust the soap dispenser settings. Hold the

remote control straight in front of the sensor at a distance of about 4-6" (10-15cm).

User Hint: Holding the soap dispenser remote control out of the recommended range (too

close or too far) may interfere with the remote's activation.

Choose the function you want to adjust by pressing on the function button as follows:*

1- SOAP VOLUME

The 1-4 drop keys allow the owner to control the desired soap dispense volume.

.004 to .013 oz

(0.2 to 0.4 ml)

Conﬁrmation: continuous blink of the red light in the sensor eye.

*The exact soap dispense volume depends on the soap viscosity. Factory setting is 0.03 oz (0.8 ml).

2- ADJ

This function allows reverting to soap dispense volume

factory setting.

Conﬁrmation: 2 blinks of the red light in the sensor eye.

3- TEMPORARY OFF FUNCTIONS

This function is ideal to perform any kind of activity in front

of the sensor without operating the system (for example,

cleaning). The soap dispenser will remain off for one (1)

minute when this button is pressed once.

To cancel this function and to return to normal operation

press the On/Off button again or wait one (1) minute.

Conﬁrmation: OFF – 2 fast blinks, ON – 4 fast blinks

4- STARTING SOAP LINE AFTER REFILLING

SOAP TANK

Once the soap tank has been ﬁlled \ re-ﬁlled, press

the FILL button. The pump will run for one (1) minute

to allow the soap to start coming out of the soap

dispenser spout.

To stop this activity press the FILL button again. If the

soap has not started coming out of the spout, check

for leaks and / or kinked or blocked or disconnected

tubing. If all ok, then press the FILL button again.

Repeat as necessary.

1408201654 Rev C

.023 to .030 oz

(0.7 to 0.9 ml)

.041 to .054 oz

(1.2 to 1.6 ml)

.071 to .078 oz

(2.1 to 2.3 ml)

27 July 2015