Asista Norco 매뉴얼 - 페이지 6

{카테고리_이름} Asista Norco에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asista Norco 12 페이지.

1. Mounting of holding unit: Click the two nylon straps

on the handlebar. Shift nylon holding unit on the straps.

Tighten the four cross bolts (not too tight). Take care to

have the holder ﬁ xed in slightly upward position.

2. Insert of nipples: Insert the two locking nipples inside

the holding unit. Mind correct position of cable holes.

3. Positioning of security cable: Feed cable from under

front structure of handlebar into the locking nipples in-

corporated at the backside of the holder. Pull both cable

ends downwards equally through the locking bushings.

4. Fixation of security cable: Fix cable on one side by

tightening the locking bolt. Pull the other end down-

wards ﬁ rmly and tighten the bolt. Please take care to

have both keybolts ﬁ rmly tightened (4 Nm).

5. Cable ends: Both ends are then to be bent to the middle

underneath the holder. (The cable may be replaced by

current type brake cable Ø 2-2.2 mm.)

6. Positioning of holding unit: Push holder downwards un-

til it is stopped by the cable. Then tighten the four black

screws in the holding unit (1 Nm). Please take care that

the unit is ﬁ xed in a slightly upward position.

7. Using: Put the accessory on the adapter and push down-

wards until it locks automatically. Press red button to

release.

Important hint: Check secure mounting of the accessory

before each ride. If you transport the bike on the car, do not

leave the accessory in the adapter!

Maximum load of the adapter 7 kg.