BlueRange TRUCK680 운영 매뉴얼 - 페이지 4

{카테고리_이름} BlueRange TRUCK680에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BlueRange TRUCK680 8 페이지. Hydraulic hand pallet truck

2. TO ATTACH DRAW-BAR TO PUMP UNIT (SUPPLIED UNASSEMBLED)

If your pallet truck has arrived unassembled, please follow the instructions to attach the Drawbar.

You will need following tools - a hammer, pliers, and spanner. Plus the following parts contained

in the enclosed bag:- Axle (A105), two cotter pins (A106) (Note one is pre fitted in the axle A105)

NOTE: The number of draw-bar and pump should be the same.

2.1 Insert the draw-bar onto the pump piston (A346), then

use a hammer to insert the axle with hole (A105) into the

hydraulic pump and draw-bar from the right to left. (See fig.

2 ).

2.2 Let control handle(A117) to the 'LOWER' position, then

pass the adjusting nut(A104), adjusting bolt(A103) and

chain(A102) through the hole of axle(A105) with your hand

(See fig. 3).

2.3 Press the draw-bar (A110, Al 10B) down, take away the

pin(#2) (See Fig. 1).

2.4 Let the control handle (A117) on 'RAISE' position, then

raise the lever plate (A315) with the pin (#2) and insert the

adjusting bolt(A103) into the front slot of lever plate (A315),

note to keep the adjusting nut (A104) on the under side of the

lever plate.

2.5 Use a hammer to tap another elastic pin (A106) into the

axle with hole (A105).

The draw-bar is now assembled to the pump.

Page 4