Asko D5434XXL S 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Asko D5434XXL S에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D5434XXL S 16 페이지. Classic dishwasher
Asko D5434XXL S에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (20 페이지)

페이지 인쇄

CONNECTING THE ELECTRIC CABLE

If the cord is not long enough, or if a hard-wire installation

is needed, follow the steps below to complete the

electrical connection.

WARNING!

Before starting this procedure, be sure the power is turned

off at the breaker/fuse box.

Connect supply cable with

a UL-listed strain relief

bushing (if nonmetallic

cable is to be used).

Connect branch circuit white

lead to N lead on filter.

Connect branch circuit black

lead to L lead on filter.

CONNECTING THE WATER SUPPLY

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water supply

line is connected.

Flush the water supply line prior to connecting it to the

water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not seated

properly, water may leak into the base pan and activate

the float switch.

Water connection should be carried out by a qualified

professional. It is important that the water supply line and

the shut-off valve have a sufficient flow volume. At least 3

gallons (12 liters) per minute must be able to pass through

the line. Connect the machine using the accompanying

supply hose. Water pressure should be 4.2-140 PSI. There

should be a shut off valve on the water pipe.

If the pipes are newly installed, it may be wise to flush them

through so that any debris is washed away. Otherwise,

debris can clog the filter in the machine's water intake

and cut off the water supply.

Only use the inlet hose supplied with the machine. Do not

reuse old or other loose inlet hoses.

Page 11

Connect ground wire to ground connection screw on

the bottom.

NOTE:

When doing a hard-wire installation, you must remove the

supplied power cord.

1. Water supply

2. Water supply valve to dishwasher (not supplied)

NOTE:

Be sure to run the PEX tubing through the hole leading

to the sink compartment before moving the dishwasher

into position.

TESTING FOR LEAKS

1. Turn on the water supply and check for leaks.

2. Turn the power on at breaker/fuse box and test the

dishwasher operation by running a Rinse & Hold cycle.

(This should take about six minutes.)

3. Turn off the electrical power and check for leaks under

the dishwasher and sink.

4. Make sure that no kinks have developed in the drain

lines.

If there are no leaks and the dishwasher seems to be

working properly, continue with the installation.

Customer Care Center

1-800-898-1879