Asko D5434XXL S 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Asko D5434XXL S에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D5434XXL S 16 페이지. Classic dishwasher
Asko D5434XXL S에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (20 페이지)

페이지 인쇄

WATER SUPPLY

WARNING!

Plumbing connections must comply with applicable

sanitary, safety and plumbing codes in your area.

The machine can be connected to either a hot or cold

water supply. If a cold water supply is used, the washing

times will be longer but the performance will not be

affected.

Connect to cold water...

If you use oil or electricity to heat your home.

Connect to hot water (max 160 °F, 70 °C)...

If you use district heating, solar power, or geothermal

power to heat your home. Choosing a hot water connection

cuts program times and reduces the dishwasher's

electricity consumption.

The dishwasher comes with a 6-foot PEX water supply

line that has a 3/8˝ NPT female connection.

After determining where the water supply line will enter

under the sink, drill a 1-1/2˝ (38 mm) access hole and run

the line to the approximate inlet valve location shown in

the figure below. The water line inlet valve is on the right

rear of the machine.

For service convenience, a shut-off valve (not supplied)

should be installed in the supply line in an easily

accessible location, such as, beneath the sink.

It is important that the water supply line and the shut off

valve have a sufficient flow volume. At least 3 gallons (12

liters) per minute must be able to pass through the line.

The water pressure should be 4.2-140 psi.

Page 6

WARNING!

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water line

is connected to the dishwasher.

1. Water supply

2. Water supply valve to dishwasher (not supplied)

NOTE:

Be sure to run the PEX tubing through the hole to the sink

compartment before moving the dishwasher into position.

Customer Care Center

1-800-898-1879