Asko TD73 사용자 지침 - 페이지 3

{카테고리_이름} Asko TD73에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko TD73 16 페이지. Tumble dryers

PROGRAM AND ELECTRICAL FEATURES TD 70 A

General design

TD 70 A have thermostat-controlled automatic programs to 47° C or 60° C and time

programs up to 60 min.

Alternative connections

Alternative connections are single-phase, 230 V, 10 or 16 A with 1900 and 2850 W

power respectively, 2-phase 400 V, 10 A, 2850 W (normal on delivery) 3-phase, 400

V, 10 A, 2850 W or 3-phase, 230 V, 16 A, 2850 W heating capacity.

Switching

Switching between the various alternative connections is made directly on the con-

nection terminal board according to directions given.

Programs TD 70 A

The automatic programs can be started in setting 1 or 2. Setting 2 is more used, and

gives drying to selected temperature, after which the program continues for about 14

minutes without any heat.

Setting 1 starts earlier in the program and has facility for reconnection of heat for

better drying of small loads.

Program 3 is a time program with setting every 10 minutes. Program 4 is ventilation

without heat, in practice the same as the end of the time program, approximately 14

minutes.

The program unit

The program unit has a mecanically marked setting points, motor with 4-min-stages

and built-in buzzer.

Pushbuttons

The pushbuttons have the following functions:

Start of program by means of starter relay

Gives 47°C in pressed-in position and 60°C in released position

Main switch

TD 70