Asko TDC145V 사용 설명서 - 페이지 19
{카테고리_이름} Asko TDC145V에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko TDC145V 20 페이지. 400v
DOOR HANGING
You can choose whether the door is hung on the right or
the left.
Follow these instructions:
1. Remove the plinth.
2. Remove the hinge, two screws.
3. Lift the door up and remove it. Support the door at the
same time.
4. Remove both door pins (top and bottom). Fit them on
the other side of the machine. Refi t the hinge.
5. Also change the hole plug (A) (on top) and the door
hinge bushing (B) (at the top and on the bottom), and
replace them on the other side of the door.
(A)
Use a fl at-bladed screwdriver to remove the plugs.
NOTA!
Be careful not to damage the appliance with the
screwdriver.
pin
(B)
6. Loosen the screws (13 in total) on the inside of the
door.
7. Loosen the inner part of the door (pull down and lift
out).
8. Switch the catch (magnetic lock) and the cover plate.
First loosen the screw holding the catch (magnetic
lock) in place. Then use a fl at-bladed screwdriver to
remove the cover plate. Refi t the catch (magnetic
lock) and the cover plate on the other side.
9. Reattach the inner part of the door with the screws
(13 in total).
10. Loosen the two screws holding the handle in place
on the door. Push out the two plastic plugs inside the
screw holes on the other side of the door. Use the two
screws to attach the handle to the other side of the
door and press the plastic plugs into the holes where
the handle was previously fi tted.
11. Refi t the door by loosening the hinge screws slightly,
affi xing the door and closing it. Retighten the hinges.
Replace the plinth.
19