Asko R2303 사용 설명서 지침 - 페이지 8

{카테고리_이름} Asko R2303에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko R2303 12 페이지. Outdoor refrigeration

페이지 인쇄

Loading tips and suggestions

•

The two telescopic shelves hold ﬁve bottles each and

are loaded with necks facing the rear. Tall bottles should

not be loaded on the bottom shelf because they may

prevent the door from closing.

•

Do not block the thermistor, located on the right-hand

side, just above the third shelf of the outdoor/indoor

refrigerator. Blocking the thermistor could impair the air

circulation and temperature control.

•

Do not allow children to climb, stand or hang on the

appliance shelves or door.. They could seriously injure

themselves and possibly cause damage to the appliance.

Wood drawer fronts

The telescopic shelf fronts on the appliance are

unﬁnished wood. Wooden parts are protected with a foil

which is to be removed. During use, oil from hands may

accumulate and stain the wood.

Natural wood may vary slightly in grain and color.

Condenser

Be sure that nothing obstructs the required air ﬂow

openings in the front of the cabinet.

For best performance, brush or vacuum lint and dirt from

the condenser once a year.

Remove the cover from the bottom rear of the

Outdoor/Indoor refrigerator to access the condenser.

Glass shelves

Tempered glass shelves in the outdoor/ indoor

refrigerator are removable for easy cleaning or for storing

larger items.

To remove a shelf, open the door completely to avoid

potential damage to the gasket. Lift up on the back of the

shelf slightly. Tilt the shelf to one side at an angle while

pulling forward.

To replace a shelf, open the door completely to avoid

potential damage to the gasket. Tilt the shelf to one side

at an angle and slide toward the back wall, placing one

side onto the shelf support. Place the other side onto

the opposite shelf support. Ensure rear locking tabs are

engaged. When installed properly, the shelf will not slide

forward when gently pulled.

QuickSpace™ Shelf

This shelf splits in half and slides under itself for storage

of tall items on the shelf below.

Step 1: Lift the back edge of the front half of the shelf.

Step 2: Pull slightly forward.

Step 3: Lower the back edge of the front half of the shelf

while sliding it underneath the back half.

The entire Quick Space shelf can be removed and

replaced (see Glass Shelves section).