5
Specify the setting method for the machine IP address.
To use [Use DHCP], [Use BOOTP], and [Use RARP] for the IP address setting, select
[On].
If selecting [Off] for [Use DHCP], [Use BOOTP], and [Use RARP], the machine does
not check the protocols.
If neither DHCP, BOOTP, nor RARP can be used, the IP address specified in [IP
Address] is allocated.
IMPORTANT
For this machine, in addition to direct allocation of the IP address to the machine,
you can use DHCP, BOOTP, or RARP to specify the IP address. When the machine
is started or reset, it checks whether DHCP, BOOTP, or RARP is being used, and
then allocates the IP address using the first available setting method.
NOTE
•
Checking whether DHCP, BOOTP or RARP can be used takes about 1 to 2
minutes; it is recommended you set unused protocols to <Off>.
•
Depending on whether you use DHCP, BOOTP, or RARP to allocate the IP
address, you need to start the DHCP server, BOOTP daemon, or RARP daemon.
6
Specify [IP Address], [Subnet Mask], and [Gateway Address].
In [IP Address], enter the machine's IP address. In [Subnet Mask] and [Gateway
Address], enter the subnet mask and gateway address used by the TCP/IP network.
NOTE
If you are using DHCP, BOOTP, or RARP, some of the items above are not used.
The values obtained from DHCP, BOOTP, or RARP are used.
7
Select <Auto Detect> or <Manual Detect> for [Ethernet Driver
Settings].
If you want to specify the ethernet driver settings automatically, select <Auto Detect>.
To specify the settings manually, select <Manual Detect>.
You can specify the communication mode and ethernet type from [Communication
Type] and [Ethernet Type] when <Manual Detect> selected.
8
Specify the protocol settings for printing.
To use [Use Raw Print] or [Use LPD Print], select [On].
Protocol Settings
2-13
2
Print Page