DoorKing 1601-083 Installation - Page 2

Browse online or download pdf Installation for Control Systems DoorKing 1601-083. DoorKing 1601-083 2 pages. Plastic folding arm kit

Print Page
Existing Stud
Top View of
Operator Housing
3A
1
Install inner arm
on hub.
Side View of
Operator Housing
1601-266-A-2-09
www.leedan.com [email protected] Toll-Free: 800-231-1414
Installing Arms
.
h u b
a r
c l e
t t o
j u s
A d
Bushing
Locknut
3
Install cable. Cable MUST clear hub!
Hub
Cut off excess cable.
Cable Eyelet MUST be installed in turnbuckle.
Adjusting and Locking Cable Assembly
Lock eye bolt with nut to keep eye bolt from twisting.
Rotate arm up and down. Adjust cable tension with turnbuckle
to level outer arm. Make sure that cable assembly is not binding
or twisting and everything moves freely.
Important: Do not adjust cable too tight or it will bind.
Copyright 2009 DoorKing, Inc. All rights reserved.
Remove stud from operator housing
and assemble as shown.
Bolt Head (Inside Housing)
3A
Washer (Inside Housing)
Pre-Crimped Eyelet
Cable Clamp
After adjusting cable tension, lock turnbuckle
with nuts to keep turnbuckle from twisting.
Inner Arm
u s
H o
t o r
e r a
O p
2
Install eye bolt into arm
hinge with vise-grips.
Attach arm hinge to
inner arm with 4
self-tapping screws.
4
Allow turnbuckle to
loosen or tighten.
Inglewood, California 90301
DoorKing Part Number
1601-083
i n g
Install outer arm
with 4 self-tapping
screws.
Outer Arm
120 Glasgow Avenue
U.S.A.