ASTRO TOOL Corp. MS3191-1 Manual - Page 2

Browse online or download pdf Manual for Power Tool ASTRO TOOL Corp. MS3191-1. ASTRO TOOL Corp. MS3191-1 2 pages. Connector assembly tooling, hand crimping tool and related types

Print Page

GAGING INSTRUCTIONS

Gaging the Tool requires Astro part # ATK 6000 Gage Kit

Assembly.

Install Astro Gage Positioner part # 4697 (MS3196-1)

Close the Handles to the fully closed position.

Using gage part # 621074 (MS3196-3), hold the Tool

closed, insert the GO Pin into the Indenter opening as

shown, see figure # 3. The Gage must pass freely between

the Indenter tips.

Using gage part # 621074 (MS3196-3), hold the Tool

closed, insert the NO GO Pin into the Indenter opening.

The Gage Pin must NOT go between the Indenter tips.

Gage Pin

CAUTION:

DO NOT CRIMP GAGE.

TOOL DAMAGE WILL RESULT.

To verify ratchet hold and release, insert NO-GO Gage Pin

into the Tool and close the Tool carefully, until the Indenters

lightly grip the Gage Pin. DO NOT CRIMP GAGE. When

the Handles are released the Tool shall not return to the full

open position.

ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,

CRIMP TOOLS AND CONNECTOR SERVICE KITS

ASTRO TOOL CORPORATION  21615 S.W. T-V HWY.  BEAVERTON OREGON 97003

Indenter

Figure # 3

503-642-9853  FAX 503-591-7766

Positioner Installed in

Tool Frame

10692

MS3191-1

MS3191-20A

MS3191-16A

MS3191-12A

MS3191-20B

MS3191-16B

MS3191-20C

MS3191-22D

MS3191-16D

MS3196-1 GAGE

TOOL SERVICE

Astro Tool's 10692 Crimp Tool is designed for long,

reliable service. If the Tool becomes inoperative or does not

gage properly, it is suggested that you contact our Customer

Service Department for a Return Goods Authorization number

and return the Tool to our factory.

Upon receipt of the Tool, Astro will inspect and overhaul

each Tool to put the Tool back into acceptable and efficient

operating condition. Worn parts will be replaced or repaired.

Please note that Astro's Quality Control system is traceable to

The National Institute of Standards and Technology (N.I.S.T.).

Service charges for tools not under warranty will be

advised upon request.

Parts that Astro deems to have been damaged due to

neglect, misuse or accident; and parts that have been altered or

repaired by persons other than Astro Tool Corp. employees

will be replaced subject to additional charge for such parts.

TOOL HAS BEEN PERMANENTLY LUBRICATED

AT THE FACTORY

Gaging Data

In-Service

Gaging

NO-GO

.0001

.0310

.0410

.0420

.0520

.0630

.0730

.0420

.0520

.0580

.0680

.0310

.0410

.0310

.0410

.0460

.0560

.0330

.0410

DO NOT OIL

10-27-97 TI692-93-3