Ametek Land VIRALERT 3 Quick Start Manual - Page 13
Browse online or download pdf Quick Start Manual for Measuring Instruments Ametek Land VIRALERT 3. Ametek Land VIRALERT 3 20 pages. Human body temperature screening system
Also for Ametek Land VIRALERT 3: Quick Start Manual (16 pages)
Print Page
HUMAN BODY TEMPERATURE SCREENING SYSTEM
4.2 Starting the Software
If you are using your own Laptop/PC, download and install the software from the
AMETEK Land website.
VIRALERT 3 LITE software is available for download from www.landviralert.com.
CAUTION
During installation of the VIRALERT 3 LITE software, your computer
may restart. Before installation, make sure to save and close any files
in other programs that you may have open.
The minimum specifications for a computer running VIRALERT 3 LITE are:
•
I3 processor or equivalent
•
4 GB RAM
•
Minimum 1 x RJ45 port and 1 x USB-A port
•
64 GB Hard disk
•
Windows 10*
*
If your Laptop/PC is running Windows 10 in S mode, then VIRALERT 3 LITE will not
run on this machine. S mode runs only applications from the Microsoft Store, and
requires Microsoft Edge for Internet browsing. To run VIRALERT 3 LITE on your
machine, it should be switched to standard Windows 10 mode. Simple instructions
for this are available from support.microsoft.com
On the Laptop/PC, click on the VIRALERT icon
1)
VIRALERT in the Windows search bar.
The software will start automatically in Measurement mode.
2)
Wait for the LED next to the cable connector on the front panel of the
Blackbody Reference Source to turn green.
3)
Position a Subject in front of the Imager. The subject must:
•
Remove glasses
•
Remove any hat, hood or mask
•
Have no hair covering the forehead
Posters which explain the screening process and provide instructions for your
staff and visitors on how to use the system are available for download from:
www.landviralert.com
WARNING
The warm-up rate of the Blackbody Reference Source is
13 °C / 23 °F per minute.
Therefore, from an ambient temperature of 25 °C / 77 °F it will
take approximately 1 minute for the source to reach the factory
default value of 38 °C / 100.4 °F.
From an ambient temperature of 0 °C / 32 °F, it will take
approximately 3 minutes to reach the default temperature
value.
VIRALERT
or search for
USER GUIDE
3
LITE
09