Astronergy CHSM60P-HC Installation Manual - Page 8
Browse online or download pdf Installation Manual for Control Unit Astronergy CHSM60P-HC. Astronergy CHSM60P-HC 12 pages. Crystalline silicon pv
Also for Astronergy CHSM60P-HC: Installation Manual (12 pages), Installation Manual (18 pages), Installation Manual (19 pages), Manual (19 pages)
Print Page
2) As for above figure d, the solid red rectangles indicate primary clamp installation positions
and the center positions of long frames where clamps can be added for additional support.
3) Illustrations (figure d e f g) of the four different methods for clamping modules on the frame
with aluminum clamps.
recommended installation position shows as below table. Note: --- means Fig f &Fig g methods
will be not suitable for the module type.
Module Series
CHSM6610M, CHSM6610M/HV,
CHSM6610P, CHSM6610P/HV,
CHSM6610M(BL)
CHSM6610P(BL)
CHSM60M-HC, CHSM60P-HC
CHSM6612M, CHSM6612M/HV
CHSM6612P, CHSM6612P/HV
CHSM72M-HC, CHSM72P-HC
To fasten the module:
a) Place the module on the two supporting bars (not provided). The bars should be made with
stainless material and treated with an anti-corrosion process (e.g., anodic oxidation
treatment) or aluminum profile. Each solar PV module needs at least four clamps to fix. Do
not make the clamp contact the glass directly or make the aluminum frame deformation in
the installation process, and avoid the shadow of solar PV components.
b)
with an M8 bolt.
c) If the bars do not come with grooves, holes of a suitable diameter may need to be drilled to
allow bolts to be attached to the bars at the same locations as mentioned above.
d) Secure each clamp by attaching plain washer, spring washer, and nut, in that order.
e) Both of close-ups of Figure h, indicating the middle clamps and Figure i, indicating the side
clamps for reference. Suggest the dimensions for middle clamps are: a
c = 8 mm, d
28 mm, and
recommended 28Nm when the property class of bolts and screws is Class 8.8.
means the
Dimension
J
A*B*C
1648*990*35
408
1648*990*40
408
1666*992*35
408
1954*990*45
489
1954*990*40
489
1954*990*40
489
1986*992*40
505
module frame should come with grooves compatible
= 9 mm. The torque for tightening the nut and bolts are
clamping range. The
K
L
M
198
---
---
198
---
---
207
---
---
299
50
200
299
---
---
299
---
---
315
---
---
40 mm, b
Note
3.2mm glass
3.2mm glass
3.2mm glass
3.2mm glass
3.2mm glass
4.0mm glass
3.2mm glass
26 mm,