Baumer HUBNER BERLIN PROFI NET microGen HMG10P Operating Manual - Page 20
Browse online or download pdf Operating Manual for Media Converter Baumer HUBNER BERLIN PROFI NET microGen HMG10P. Baumer HUBNER BERLIN PROFI NET microGen HMG10P 44 pages. Incremental encoder with magnetic sensing
Also for Baumer HUBNER BERLIN PROFI NET microGen HMG10P: Mounting And Operating Instructions (32 pages), Mounting And Operating Instructions (40 pages)
Print Page
5
|
Installation
1
Self-locking nut M6 (ISO 10511)
3
Grounding strap
5
Through hollow shaft
7
Torque arm
9
Washer B6.4 for grounding strap
(ISO 7090)
Tool
n
10 mm
n
1,6×8 mm
n
Measuring gauge
n
Instruction:
a) Verify drive shaft about any concentricity error (see further links).
b) Mount the encoder in a way ensuring the electrical connection is protected against water
ingress.
c) Apply grease onto the drive shaft.
d) Loosen the Torx screw on the clamping ring a little. Do not unscrew the screw completely.
e) Slide the encoder onto the drive shaft.
f) Tighten the Torx screw on the clamping ring with a torque of 2-3 Nm.
g) Mount the torque arm together with threaded rod, washers (3x) and self-locking nuts (3x).
Observe the torque arm mounting instructions (see further links).
h) Attach grounding strap using cheese head screw and washer.
Also see about this
2 Avoiding and calculating angular errors [} 24]
2 Mounting the torque arm at drive [} 21]
20
1
4
10 mm
Operating Manual
2
3
1
4
9
8
4
7
1
2
Threaded rod M6 (variable length ≤ 210 mm)
4
Washer B6.4 (ISO 7090)
6
Torx screw M3x12 mm (ISO 7045)
8
Cheese-head screw M6x8 mm for grounding
strap (ISO 1207)
>113 mm
5 6
HMG10 & HMG10P EtherNet/IP | V1, T1
Baumer Hübner