AMPLISONIC V8 FOUR 30W User Manual - Page 2

Browse online or download pdf User Manual for Musical Instrument Amplifier AMPLISONIC V8 FOUR 30W. AMPLISONIC V8 FOUR 30W 3 pages. Point-to-point guitar amplifier

Print Page
DEPTH Knob
To adjust the tremolo depth. This is true "vintage" tremolo that adjusts the power amp section so when set to full you will
hear the depth clearly coming from your speakers. Tremolo footswitch connection is on back panel.
SPEED Knob
To adjust the tremolo speed.
GEAR Knob
To adjust the output power with four different options.
1 - position: High voltage level is reduced greatly and you will get approx. 5 watts output with max sustain.
2 - position: High voltage level is reduced less and you will get approx. 10 watts output with good amount of sustain.
3 - position: Only two middle tubes are operating and you will get approx.15 watts output. Side tubes can also be removed.
4 - position: All four tubes are working to give full 30 watts. If you want clean sound just turn GAS to the max and adjust
level with DRIVE. BOOST then gives you that extra cut when needed.
HEAT Switch
To turn the machine on. In correct operation keep the RUN switch turned off and warm up power tubes for a minute.
RUN Switch
To switch on the high voltage. You are ready to rock!
INPUT Jack (left side)
To connect your guitar.
OUTPUT Jack (right side)
Tremolo Footswitch connector or optionally line out by switching cable from TREM F.S to the LINE OUT jack.

BACK panel

8
LINE
TREM
IN
4
16
OUT
OUT
F.S
i
o
230
1
2
REV
F T2A
OHM
230/115 VAC Switch
To adjust the voltage. Check your operating country before connecting mains.
MAINS Input
To connect the mains cable. This connector contains the main fuse: 2.0A and remember to use slow blow fuse.
Lights Connector
RCA, 12V voltage output for parking lights.
OHM Selector
To adjust the impedance. Switch to correct setting according to combined speaker impedance.
OUT Jacks (parallel)
To connect your speakers. Remember to connect your speaker before powering the unit.
LINE OUT Jack
Output from the speaker line. This can be used for PA and recording purposes. Output impedance 3.3 Kohm.
You can also connect the front panel jack to this for easy access.
TREMOLO F.S Jack
To connect the tremolo footswitch. To use the front panel jack connect its cable to this jack.
Reverb Connectors
RCA, Input and output for the reverb tank.
IN Jack
You can also connect your guitar to this jack directly by removing the front panel input cable.