AmpliVox SB8001 User Manual - Page 4
Browse online or download pdf User Manual for Speaker System AmpliVox SB8001. AmpliVox SB8001 8 pages. With bluetooth battery powered pa system
CONTROL / BACK PANEL
ADJUSTABLE PULL OUT HANDLE
EXPANSION SLOT FOR
WIRELESS MICROPHONE
WIRELESS MICROPHONE
16 CHANNEL UHF RECEIVER
CD / MEDIA PLAYER
WIRED MICROPHONE XLR /
1/4" COMBO JACK with
VOLUME / TONE / ECHO
CONTROLS:
To connect balanced or unbalanced
microphones that have either XLR or
phone plug connectors.
XLR INPUT/OUTPUT JACKS:
Used with POWERED speakers or
output to other electronics
FUSE:
5A 250V
System Protection
EXTERNAL SPEAKER:
1/4" JACK, use with PASSIVE
speakers only
OPERATION
POWER SWITCH:
When power switch is in the ON position, the
red LED on switch will be illuminated. The BATTERY STATUS
LIGHTS (4 LED's) will indicate the condition of the battery. Each LED
represents about 25% of battery charge. If no LED's are lit, battery
must be recharged before use.
To charge the batteries, connect the unit to 110V AC using the sup-
plied power cord. The LED's will flash indicating battery is charging.
When they stop flashing, batteries are fully charged. While charging
you may hear a high pitch sound. This is normal. It is noise from the
charging circuit.
The batteries will charge when unit is operating with AC power,
HOWEVER the unit will charge faster with the power switch in
the "off" position.
THE SW800 SHOULD BE PLUGGED IN AND CHARGING WHEN
NOT IN USE TO MAXIMIZE BATTERY LIFE. RECHARGING THE
UNIT ONLY WHEN THE BATTERY STATUS LIGHT IS RED WILL
SHORTEN THE USEFUL LIFE OF THE BATTERIES.
MICROPHONE / BODYPACK /
REMOTE CONTROL
STORAGE COMPARTMENT
Not Used
BATTERY PANELS
User Accessible
FUSES:
charging does not start, please check fuse. There is a fuse in
the AC jack. It is identified on the plastic with a drawing of a
fuse.
Detach the AC cord from the unit before replacement.
This fuse protects the AC circuitry. Use a flat blade screwdriver
in the slot on the top of fuse holder to slide the fuse holder out.
Replace the fuse with a 10A/250V fuse if needed.
If battery charger works but PA system does not, check
System Protection Fuse. Unscrew cap to check.
If after replacing fuse, the SW800 does not "power on", please
call AmpliVox Customer Service at 800-267-5486.
WARNING! RISK OF SHOCK! DO NOT OPEN UNIT.
4
When the AC cord is plugged in, and the battery
NO USER SERVICEABLE PARTS INSIDE!
POWER SWITCH
BATTERY STATUS
LED LIGHTS
BLUETOOTH MODULE
AUDIO CONTROL KNOBS:
Master Volume Control
Bass Control
Treble Control
MICROPHONE VOICE
PRIORITY SWITCH
LINE INPUT with
VOLUME
CONTROL:
Used to connect MP3 players,
portable tape and CD players
IEC TYPE AC
CONNECTION with FUSE:
Line Voltage Protection