AMPULLA SENTRY User Manual - Page 10

Browse online or download pdf User Manual for Dash Cameras AMPULLA SENTRY. AMPULLA SENTRY 17 pages.

Print Page

8. Basic Operation

8.1

The device will power ON/OFF automatically with the car

when engine starts/stops, and it can also be turned on by

PRESSING AND HOLDING the On/Off button until the

splash screen is displayed.

The device needs to operate with a Class10 micro SD

memory card. Make sure the card is placed into the slot in

the right position and press it further into the slot until it

completely locked in the place. To remove the SD card,

press firmly on the SD card further into the slot. There will

be a click and the SD card will pop out on release.

You can charge the device with the included car charger

or with the most of USB ports.

The built-in battery is only intended to maintain device's

operation after power been accidently cut off due to an

accident or crash. Note that, this battery is not for

- 17 -

long-term recording.

Press

MENU to enter settings, press 'UP' or 'DOWN'

buttons to find the setting you want to select or change

and then press

OK button to select or confirm your

changes. Pressing MENU at any time will exit the menu

without saving changes.

8.5.1 Setting Video Resolution

The default setting is 1920x1080P/30fps (fps: Frames per

second). Choose the resolution of video recording:

1920x1080P/30fps (FHD), 1920x1080P/30fps (HD).

8.5.2 Setting Loop Recording

You can choose the setting to 1mins, 2 mins, 3 mins or 5

mins. The default setting is usually 3 mins, which means

every video clip will be last for 3 minutes.

Once the memory card is full, the camera will

continuously overwrite the oldest video clip recorded. To

protect a clip so that it will not be overwritten, press the

Emergency Lock button. And the emergency record

- 18 -