Bosch DISHWASHER Operating Instructions Manual - Page 26

Print Page

Bosch DISHWASHER Operating Instructions Manual

Electrical connection

– Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See rating

plate for required fusing 92.

– The socket must be near the appliance

and freely accessible following

installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side to satisfy

the relevant safety instructions.

– The connection may be modified by

technicians only.

– A power cord extension may be

purchased from customer service only.

– Use only a residual current operated

circuit-breaker which features

the symbol ‚. Only this extension

guarantees compliance with

the currently valid regulations.

– The appliance features a water

damage protection system. Please

note the system will not function

unless the power supply is connected.

Removing the appliance

Also observe the sequence of worksteps

here.

– Disconnect the appliance from

the power supply.

– Turn off the water supply.

– Disconnect the waste water and fresh

water connections.

– Loosen fastening screws for the

furniture parts.

– If fitted, remove the base panel.

– Pull out the appliance, carefully pulling

the hose behind.

Transportation

Empty the dishwasher and secure loose

parts.

Drain the appliance according to the

following steps:

– Turn on the tap.

– Close the door.

– Switch on ON/OFF switch (. The

displays of the last selected

programme light up.

– Select programme with the highest

temperature.

The expected programme duration is

indicated on the numerical display

)*.

– Press START button h.

Programme sequence starts.

– After approx. 4 minutes press the

START button h until :

indicated on the digital display.

After approx. 1 min :

on the digital display .

– Switch the appliance off ( and turn

the tap off.

Transport appliance upright only.

(This prevents residual water from running

into the machine control and damaging

the programme sequence.)

Protection against frost

P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e )

If the appliance is in a room where there is

a risk of frost (e.g. holiday home), empty

the appliance completely (see

Transportation).

– Turn off the tap, disconnect supply

hose and drain water.

is indicated