Bosch DISHWASHER Installation Instructions Manual - Page 15

Print Page

Strain Relief

(not supplied)

Figure 26

Strain Relief Plate

Figure 27

Electrical Connection

ELECTRICAL CONNECTION

Strain

HAZARD - Working on an energized circuit

Relief

could result in serious injury or death. Only

Plate

qualified electricians

should perform electrical work. Do not

attempt any work on the dishwasher electric

supply circuit until you are certain the circuit

is de-energized.

Improper electrical work can cause fire. Only

qualified electricians should perform electri-

cal work.

Grounding Instructions

The dishwasher must be properly grounded before

operating. This appliance must be connected to a

grounded metal permanent wiring system, or an equipment

grounding conductor must be run with the circuit

conductors and connected to the equipment grounding

terminal or lead on the dishwasher. Make sure that the

dishwasher is connected to a suitable ground in

compliance with all local codes or, in the absence of a

local code, with the NATIONAL ELECTRICAL CODE in the

United States or the CANADIAN ELECTRIC CODE C22.1-

latest edition in Canada as well as any provincial/state or

municipal or local codes that apply.

1) Retrieve the strain relief plate, and install a strain relief

(not supplied) into the opening on the strain relief plate.

NOTE: Orient the strain relief as shown in Figure 26.

2) Pass the electrical supply cable through the strain relief,

as shown in Figure 27. Leave 3 - 4 inches of insulated wire

extending through the strain relief plate.

3) Tighten the strain relief screws.

4) Slide the strain relief plate into the junction box, and

secure it to the junction box with the supplied screw.

(Continued on next page)

WARNING: ELECTRICAL SHOCK

WARNING: FIRE HAZARD -