Electrolux EW 1013I Instruction Booklet - Page 23

Browse online or download pdf Instruction Booklet for Washer Electrolux EW 1013I. Electrolux EW 1013I 28 pages.

Print Page

132984330.qxd

21/07/2005

10:20

Water inlet

Connect the hose to a tap with a 3/4" thread.

Do not use previously used hoses for water connection.

Installation should comply with local water authority

and building regulations' requirements.

The appliance must be connected to a cold water

supply.

A minimum water pressure of 0.05 MPa (0.5 bar) is

required for safe operation of the appliance.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(16.5 ft) between the appliance's inlet and the bottom of

the water storage tank.

Set the hose correctly by loosening the ring nut. After

positioning the inlet hose, be sure to tighten the ring nut

again to prevent leaks.

This appliance is designed to be permanently plumbed

into your home's drainage system using one of the

following methods.

1. Into a drainage standpipe.

Firstly form a hook in the end of the drain hose using

the "U" piece" supplied.

Pagina

(Nero/Process Black pellicola)

Place the drain hose into your standpipe, which should

have an internal diameter of approximately 38mm thus

ensuring there is an air break between the drain hose

and standpipe.

When discharging into a standpipe ensure that the top of

the standpipe is no more than 90cm (35.4'') and no less

than 60cm (23.6'') above floor level.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece is

available from your local Service Force Centre.

The joining piece must have an internal diameter of 18mm.

If your drain hose looks like this (see below) you do not

require the "U" piece". Just push the hose firmly into

the standpipe.