ATIGO A1001 User Manual - Page 3

Browse online or download pdf User Manual for Intercom System ATIGO A1001. ATIGO A1001 8 pages. 2-wire audio receiver

Print Page

Audio Receiver A1001

Receptor is picked up to answer the visitor

calls.

Unlock button is used to release the door

lock when pressed.

Call button / Unlock 2

make a intercom call to another handset

when in standby mode. During an active call it

can be used to release a secondary door like

a back entrance or a gate.

Speaker is used to hear the caller.

Power supply: 24Vdc (supplied by A2100)

Power consumption: 2.1mA standby

75.9mA active

Wiring: two wires, non-polarised

Dimension: 187(H) x 97(W) x 33(D)mm

button is used to

The audio door entry handset is configured by

six DIP switches marked as DIP1.

The DIP switches can be modified before or

after installation. Restarting the unit is

necessary whenever the DIP switches have

been modified.

DIP1 switches 1 to 6 are for setting the audio

handset user code.

DIP2 switches 1 to 3 are used to set the

audio handset as secondary or extended.

SW+, SW- is used to connect an external

doorbell button.

L1, L2 is used to connect the BUS wires.

K3 is used to set the volume setting.

K4 is used to set the ring tone.

OFF Programming mode disabled.