Andesfit Health ADF-B27 User Manual - Page 12

Browse online or download pdf User Manual for Blood Glucose Meter Andesfit Health ADF-B27. Andesfit Health ADF-B27 18 pages.

Print Page

The results obtained from this meter are plasma-calibrated. This

helps you and your physician or other qualified healthcare

provider to compare your meter results with laboratory tests.

Reference to the instructions given by your physician or other

qualified healthcare provider, do not deviate from these instructions

on the basis of the result without first consulting your physician.

Step 8

Eject the used test strip and remove the lancet. To

eject the test strip, point the strip at a disposal

container for sharp objects. The meter will switch

itself off automatically after the test strip is ejected.

Please wash hands thoroughly with soap and

water after handling the meter, lancing device, or

test strips.

Reference value:

Time of day

Before breakfast (fasting)

Two hours after meals

Source: American Diabetes Association. Standards of Medical

Care in Diabetes-2012.Diabetes Care 2012,35（Suppl.1)S11-S63.

Please work with your doctor to determine a target range that

works best for you.

People without diabetes

<100 mg/dL

<140 mg/dL

The meter provides you with whole blood equivalent results. The

result you obtain from your meter may differ somewhat from your

laboratory result due to normal variation. Meter results can be

affected by factors and conditions that do not affect laboratory

results in the same way. To make an accurate comparison

between meter and laboratory results, follow the guidelines below.

Before going to the lab:

■ Do a control solution test to make sure that the meter is

working properly.

■ Fast for at least eight hours and then do comparison tests,

if possible.

■ Take your meter with you to the lab.

While staying at the lab:

Make sure that the samples for both tests test are taken and

tested within 15 minutes of each other.

■ Wash your hands and then obtain a blood sample

■ Never use your meter with blood that has been collected in

a gray top test tube.

■ Use fresh capillary blood only.