andi be free Vent Mount Manual - Page 3

Browse online or download pdf Manual for Battery Charger andi be free Vent Mount. andi be free Vent Mount 15 pages. Wireless charger for car

Print Page

Connecting the Charger

•

Remove the Vent Mount Charger from the package and connect the

included USB C cable to the charger head.

•

Inspect the andi be free® Wireless Vent Mount Charger, as well as all

included accessories, for damage. A defective device must not be put

into operation under any circumstances.

•

Check if the mechanism [1] of the hook is compatible with your venti-

lation. The hook must fit through the fins.

•

Insert the hooking mechanism through the ventilation grille of your car

through the lowest slat [2] and hook it.

Turn the rotating mechanism [3] until it is fixed firmly to the vent

•

(if you tighten it too much, the slats can break)

•

By loosening the screw nut [4] behind the charging head, the charging

head can be tilted to your desired position and tightened again.

•

The USB C cable needs to connected with the USB port of the car or a

power plug for the cigarette lighter.

Attaching the andi be free® Sticky Pad

• • To improve the adhesion of the andi be free®

To improve the adhesion of the andi be free®

Sticky Pad, it is necessary to clean the back of your

smartphone or smartphone case. Please use

cleaning agents and accessories suitable for

smartphones or cases.

• • Place your smartphone (or case) with the

Place your smartphone (or case) with the

display facing down on a flat surface where it

cannot be scratched.

• • Place the template on the back of the smartphone/case, making sure you

Place the template on the back of the smartphone/case, making sure you

can read the millimeter markings on the edges of the smartphone/case

Move the template until the millimeter readings on the right and left side

If you use an

iPhone that

has MagSafe,

you don't need

an adhesive

pad or case.