Atkinson Electronics GSCM-MINI-50 Manual - Page 8
Browse online or download pdf Manual for Control Unit Atkinson Electronics GSCM-MINI-50. Atkinson Electronics GSCM-MINI-50 12 pages. Generator start control module - mini (2 wire to 3 wire)
Print PageGENERATOR START CONTROL MODULE - MINI (2 Wire to 3 Wire)
GSCM-MINI-50HZ
APPLICATION 1 - REMOTE RV GENERATOR START CONSOLE REPLACEMENT
The GSCM-mini can be used in place of or to replace a typical remote generator control console, that is mounted on the
dash of a motor-home. Instead of a large console unit and cable, the mini uses a small 4 wire 18 gauge signal cable, an
on-off switch with built in light and a separate 12VDC fault light. When the remote switch is turned on, the mini starts
the generator. After the generator starts and comes up to speed the "run" LED lights on the mini and lights the remote
start switch light. If the generator fails to start or fails while commanded to run the "fault" LED on the GSCM mini lights
along with the remote fault 12VDC light. Turning off the power to the GSCM mini resets the fault condition and it is ready
to receive another start command.
ATKINSON ELECTRONICS, INC.
REV 5/08
Web Site: www.atkinsonelectronics.com
Distributed by: