Atlantic Ultraviolet Sanidyne Prime 40-0673A Owner's Manual - Page 8
Browse online or download pdf Owner's Manual for Accessories Atlantic Ultraviolet Sanidyne Prime 40-0673A. Atlantic Ultraviolet Sanidyne Prime 40-0673A 16 pages. Ultraviolet portable area sanitizers
Print Page
u
P
nit
laCement
•
The Sanidyne
Prime Portable Area Sanitizer does not require professional installation.
®
•
The Sanidyne
should this sanitizer be permitted to operate with humans, plants, or animals present in the Operation Area.
•
Electrical power supplied to the Sanidyne
•
The Sanidyne
Prime is intended for indoor use only. The Sanidyne
®
as dripping water, condensation, or mist, and used only in a clean, dry location with temperature ranges between 40°F to 95°F.
•
For maximum efficiency, the Sanidyne
treatment area. The Sanidyne
and the ultraviolet rays are unobstructed.
•
Access to the room MUST be avoided while the Sanidyne
l
i
amP
nstallation
Germicidal lamps are easily damaged. Exercise care when handling lamps.
Always disconnect power to the fixture before performing any service or maintenance.
Always Disconnect Power to the
Sanidyne
Prime
®
1.
Remove protective storage cover
by releasing the three latches on the
storage cover.
2. Remove the top cover after loosening
the four thumbscrews.
3. Holding the lamp vertically by the
pinless base, align the connector pins
on the lamp base with the socket below.
4. Carefully insert the lamp into the socket.
5. Carefully snap lamp into the lamp guide
located on the lamp guard assembly.
6. Install the remaining seven lamps as
described in steps 3, 4, and 5.
7. Re-install the top cover and tighten the
four thumbscrews.
8. Replace the storage cover and secure
using the three latches.
8
Prime is intended for use in UNOCCUPIED AREAS ONLY. Under no circumstances
®
Prime must match power requirements listed on the unit.
®
Prime should be located as centrally as possible, away from the corners of the
®
Prime Portable Area Sanitizer is most effective when it is located in the center of the room
®
IN ORDER TO PERFORM THIS TASK, BE SURE TO WEAR THE FOLLOWING SAFETY
EQUIPMENT: SAFETY GLASSES OR A FACE SHIELD, AS WELL AS GLOVES.
Step 1 – Release Latches
Prime should be protected from liquid intrusion such
®
Prime is operating.
®
Step 3 – Hold Lamp by Pinless
Base & Align Connector Pins
with Socket Below
Step 2 – Loosen Four Thumbscrews
Step 4 – Insert Lamp into Socket
Step 5 – Snap into Lamp Guide