ADVANCED Network Devices IPCSS-RWB Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Monitor ADVANCED Network Devices IPCSS-RWB. ADVANCED Network Devices IPCSS-RWB 2 pages. Clock

Print Page

Boot Sequence

When first powered, if properly installed, the device should boot and then display the

time, as follows:

Boot sequence

Troubleshooting and Other Tips

Startup Questions:

Tips/Tricks:

http://www.anetdsupport.com/faqs/general-questions

Troubleshooting:

http://www.anetdsupport.com/faqs/troubleshooting

Complete support site with user guides and help:

Clock Installation Instructions

(IPCSS-RWB/IPCSL-RWB/IPSIGNL-RWB)

http://www.anetdsupport.com/faqs/startup-questions

For additional support, visit

This is the 1st screen seen, and you will hear the AND

jingle during it. This screen should come on within 1-2

seconds of powering on the device.

This indicates the current firmware the device is

equipped with.

The network MAC address of the device. This is

configured at the factory.

The device is now looking for a DHCP server among

other things.

If it hangs in this state, there is a good

chance there is a network problem (cable, switch, ISP,

DHCP,

etc.).

The IP address of the device. This is network specific,

and depends what DHCP assigns it or static if configured

as such. You should hear an audio beep during this

stage.

Once all initialization is done, the time will be displayed.

If just a colon is displayed, it is alive, but cannot find the

time. Check the NTP server settings and check that the

internet connection is working.

http://www.anetdsupport.com/

www.anetdsupport.com

Version 1.5

4/20/2015