Atlas DAGNY Instructions Manual - Page 3

Browse online or download pdf Instructions Manual for Fan Atlas DAGNY. Atlas DAGNY 10 pages. Ceiling mounted rotational fan

Print Page

READ AND SAVE THESE SAFETY AND INSTAllATION

Consult a licensed electrician if unsure of any point below mentioned.

DANGERIWARNING/CAUTION

1. Hi9.hvoltage and. moving parts around motors and motor driven equipment can cause

senous or fatal InJunes. Always disconnect power source at main switch before wiring,

servicing or cleaning unit. Do not rely on fan control device to prevent unexpected

start-up or electrical shock. In addition, power supply must have fuses or circuit

breakers for short circuit protection.

2. All electrical wiring must conform to national and local electrical codes such as: NEC,

OSHA, etc.

3. Fan should be secure in its electrical grounding to avoid possible electrical shock.

4. Fan should not be used in any wet or hazardous location defined by article 500 of the

NEC. In addition, its ambient temperature should not exceed 104 degrees Fahrenheit.

5. Power supply should conform to voltage rating of 120V.

6. Before applying power, visually re-inspect the installation. Make sure that all guards

and protective devices are securely in place and all visible screws and bolts are

tightened.

7. Warning: to reduce the risk of fire, electrical shock or personal injury, mount hanging

bracket to outlet box marked "Acceptable for fan support and a hanging weight of 45

Lbs." Do not mount fan to sheet rock or drywall type materials and use only the screws

provided with the oullet box.

8. Caution: to reduce the risk of injury to persons, install fan so that bottom edges of fan

blades are to be:

**In Canada, to satisfy CSA requirements: at least 8.3 FU2.5 M above the floor and all

objects in room if safety cages are utilized. 10.0 Ft if safety cages are not utilized.

**In the US, to satisfy UL requirements: at least 7.0 Ft above the floor and all objects in

room if safety cages are utilized. 10.0 Ft. if safety cages are not utilized.

9. To reduce the risk of personal injury, do not bend blades or any other part of fan when

cleaning. Do not insert foreign objects in between rotating fan blades or in space

surrounding entire rotating fan unit. Fan must be turned off at power at supply source

before installation, cleaning or servicing.

10. Instructions for Supply Connections: Conductor of a fan identified as grounded

conductor to be connected to a grounded conductor of a power supply, conductor of

fan identified as ungrounded conductor to be connected to an ungrounded conductor

of a power supply, conductor oUan identified for equipment grounding to be connected

to an equipment-grounding conductor. After making the wire connections in junction

box, the splices should be turned upward and pushed carefully into the outlet box. The

wires should be spread apart with the grounded conductor and the fan-grounding

conductor on one side of the junction box and the ungrounded conductor on the other

side of the oullet box. Be sure that all wiring connections are properly insulated from

each other and any surrounding metal parts. For safety and best operating results, we

recommend that you have a qualified electrician assemble and install your fan.

INSTRUCTIONS.