Annovi Reverberi Blue Clean 810 Product Manual - Page 9

Browse online or download pdf Product Manual for Pressure Washer Annovi Reverberi Blue Clean 810. Annovi Reverberi Blue Clean 810 9 pages. Annovi reverberi power-jet cleaner product manual

Print Page

English

6.3 Oil Change

Caution - Danger!

Spent oil must not be dumped because it is a

pollutant. It must be disposed of in accordance with

legal requirements.

Change pump and reduction gearbox oil (where fitted)

after first 50 hours of operation, and every 500 hours

thereafter.

Remove the casing (where fitted) to change the oil.

Replace the casing (where fitted) when done.

6.3.1 Changing the pump oil

Unscrew the drain plug and allow all the spent oil

to flow out.

Screw the plug back into place.

Pour in oil through the filler hole.

Check that the oil level is correct.

For oil characteristics, refer to the "Oil characteris-

tics" table.

6.3.2 Changing the reduction gearbox oil (where fitted)

Unscrew the drain plug and allow all the spent

oil to flow out.

Screw the plug back into place.

Pour in oil through the filler hole.

Check that the oil level is correct.

For oil characteristics, refer to the "Oil character-

istics" table.

TROUBLESHOOTING

Problem

Pump does not reach work-

ing pressure

Pressure drops during use

Water leakage

Cleaner noisy

Oil leakage

Engine malfunction

Water escapes from ther-

mostat valve

Possible causes

Nozzle worn

Water filter fouled

Water supply pressure low

Air being sucked into system

Air in pump

Adjustable nozzle not positioned correctly

Water intake from external tank

Intake water too hot

Nozzle clogged

Seals worn

Water too hot

Seals worn

Water temperature inside nozzle has exceeded

max. rated value stated on nameplate

Table 1 - Oil characteristics

Component

Pump 850

SAE 30 W

Pump 840

SAE 30 W

Pump 830

SAE 30 W

Pump 820

SAE 30 W

Pump 810

SAE 75 W90

Reduction

AGIP BLASIA W90

gearbox

6.4 Storage

Treat the appliance with non-corrosive, non-toxic anti-

freeze before storing it away for winter.

Replace nozzle

Clean filter (fig.5)

Turn on water supply tap fully

Check tightness of hose fittings

Switch off the cleaner and keep depressing and

releasing the gun trigger until the water comes out

in a steady flow. Switch the cleaner back on again.

Turn the adjustable nozzle "E" (+) (fig.3)

Connect cleaner to the mains water supply

Reduce temperature

Clean nozzle (fig.5)

Have the seals replaced at your nearest Authorised

Service Centre

Reduce temperature (see technical data

Contact your nearest Authorised Service Centre

Refer to the engine manufacturer's manual.

With appliance in operation, do not stop the water

jet for more than 5 minutes at a time

Oil type

Quantity (kg)

0.9

0.3

0.135

0.21

Remedy