Anova rcp6 Assembly And Use Instructions - Page 3
Browse online or download pdf Assembly And Use Instructions for Indoor Furnishing Anova rcp6. Anova rcp6 4 pages. Recycled plastic picnic table
Print Page11. Return to the Table Top Assembly. Orient the Table Top so that the top surface is facing upward. Start one T30 x 3" Washer Head
Screw into each of the corner pilot holes. Stop when the point of the screw emerges from the bottom side of the Table Top.
Carefully lift the Table Top Assembly and position it over the assembled Leg Structure and line up the emerging points of the
Washer Head Screws with the appropriate pilot holes in the Leg Mount component of the assembled Leg Structure.
Use the Torx T30 Driver
to drive the Washer Head
Screws into the Leg Mount
until tight. Once these four
Screws are secured, the
remaining Washer Head
Screws can be inserted and
driven into the rest of the
Table Top pilot holes.
After the Table Top is
secured, tighten all of the
Carriage Bolts and Hex
Nuts in the Leg Structure.
12. Carefully turn the Table upside down onto a padded work surface.
Start two T25 x 2.5" Torx Screws into the pilot holes in the center of the both Seat Supports. Locate the two Angle Braces. Start
two T25 x 2.5" Torx Screws into the pilot holes on the notched end, just enough to hold them in place.
Position one of the Angle Braces so the
notched end fits over the edge of the Angle
Brace Mount near the center Table Top and
the other end of the Angle Brace contacts
the center of the Seat Support where the
two Torx screws are started.
While one person holds the Brace in place,
another person should drive the Torx Screws
through the Seat Support, into the end
of the Angle Brace. When those outside
Screws are secure, drive the two started
Screws through the Brace and into the
Angle Brace Mount.
Install the remaining Angle Brace in the
same manner.
13. Position one of the Angle Supports on the Table Top with the cutouts positioned over the Angle Brace Mounts. Make sure the
mounting flange is facing out toward the edge of the table. Install the nine Phillips Head Screws through the Angle Support and
into the Table Top first.
Note: Install the Screws from the
center of the Table, alternating
outward towards the ends of the
Table.
Keep the Angle Support pressed
against the Angle Brace when
installing the screws.
Start the four corner T30
Washer Head Screws first
T30 Washer
Head Screws
Tighten hardware
after the Table
Top is secure
T25 x 2.5"
Torx Screws
Angle Brace Mounts
Seat Stiffener removed
from illustration for clarity
Angle Brace
T25 x 2.5"
Torx Screws
Angle Brace Mounts
Leg Mount
Tighten hardware
after the Table
Top is secure
Leg Mount
Seat Support
Angle Brace
Phillips Screws
Angle Support with
mounting flange
outward
T25 x 2.5"
Torx Screws
3 of 4