DSC PC255O Instruction Manual - Page 2
Browse online or download pdf Instruction Manual for Security System DSC PC255O. DSC PC255O 8 pages.
Also for DSC PC255O: Instruction Manual (17 pages), Frequently Asked Questions Manual (18 pages)
Print Page
Canadian Department of Communications Notice
NOTICE: The Canadian Department of Communications label identifies certified
equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements. The
Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection. In some cases, the
company's inside wiring associated with a single line individual service may be
extended by means of certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
User should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe system, if present,
are connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electrician, as
appropriate.
The Load Number (LN) assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop which is used by the device, to
prevent overloading. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the Load Numbers of all the
devices does not exceed 100.
The Load Number of this unit is 42.
SYSTEM REFERENCE
Zone
Protected Area
1
________________________________
2
________________________________
3
________________________________
4
________________________________
5
________________________________
6
________________________________
7
________________________________
8
________________________________
Fire Zone ________________________________
[F] Key
Enabled
[A] Key
Enabled
[P] Key
Enabled
Access Codes
Master Code: ___________
[2] _____________ [3] _______________ [4] _______________ [5] _______________
[6] _____________ [7] _______________ [8] _______________ [9] _______________
[10] ___________ [11] ______________ [12] ______________ [13] ______________
[14] ___________ [15] ______________ [16] ______________
Entry and Exit Times
Entry Delay: __________ seconds
Exit Delay: ____________ seconds
Monitoring Station Information
Account: __________________________________ Phone: _____________________
For Service:
Contact: ___________________________________ Phone: _____________________
Zone Type
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
Disabled
Disabled
Disabled
Auxiliary Entry Delay: __________ seconds
Auxiliary Exit Delay ___________ seconds
1