ATV E-GA08 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Offroad Vehicle ATV E-GA08. ATV E-GA08 17 pages.

Print Page

The charger supplier with the vehicle should be regularly examined for damage to the

cord, plug, enclosure and other parts, and in the event of such a damage, the bike must

mot be charged until the charger has been repaired or replaced.

Use only with the recommended charger.

Use caution when charging.

The charger is not a toy. Charger should be operated by an adult.

Do not operate charger near flammable materials.

Unplug charger and disconnect from bike when not in use.

Always disconnect from the charger prior to wiping down and cleaning the vehicle with liquid.

FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS

INCREASES RISK OF SERIOUS INJURY. USE WITH APPROPRIATE CAUTION AND

SERIOUS ATTENTION TO SAFE OPERATION.

BEFORE YOU BEGIN

Remove contents from box. Remove the foam separators that protect the components from

damage during shipping. Inspect the contents of the box for scratches in the paint, dents or

kinked cables that may occurr during shipping. Because the product was 85 percent

assembled and packed at the factory, there should not be any problems, even if the box has

a few scars or dents.

MAKE SURE KEY SWITCHES IS TURNED " OFF" BEFORE CONDUCTING

ANY PROCEDURES.

Estimated Assembly and Set-Up Time

We recommend assembly by an adult with experience in motorbike or bicycle mechanics.

Allow up to 30-40 minutes for assembly, not including initial charge time.

Allow up to 12 hours for initial charge.

NOTE:The 6" rear tires are inflated when shipped, but they invariably lose some pressure

between the point of manufacturing and your purchase. Always inflate the tires to the

correct PSI before first time use.

Please read the specification sheet to get the information of tire pressure.

Using a bicycle-style tire pump to inflate the tire to the PSI indicated on the sidewall of the tire.

Note: The pressurized air supplies found at gasoline stations are designed to inflate high-

volume automobile tires. If you decide to use such an air supply to inflate your tires, first

make sure the pressure gauge is working, then use very

short bursts to inflate to the correct PSI. If you inadvertently over-inflate the tire, release the

excess pressure immediately.

Important information of use guider for tire

Note: Tire is the only contact between the vehicle to the road, the safety of various driving

activity depends on the small area of tire where contact with the road. Therefore, it is very