3T-Components 3T-MOTORS 3T45-10E Installation & Operating Instructions Manual - Page 7

Browse online or download pdf Installation & Operating Instructions Manual for Engine 3T-Components 3T-MOTORS 3T45-10E. 3T-Components 3T-MOTORS 3T45-10E 12 pages. Shutter motors with obstacle detection and electronic limit switches

3T-Components 3T-MOTORS 3T45-10E Installation & Operating Instructions Manual
INSTALLATION INSTRUCTIONS

Prepare motor for installation:

3
When changing the adapter set (SW50 or SW70): Press the safety catch with a screwdriver and pull off the shaft adapter at the same time.
Then replace limit switch adapter and put shaft adapter on adapter holder.
Push limit switch adapter flush against motor head.
Push the motor into the roller shutter shaft without using force (never knock it in). The fold of the shaft must lie over the recess in the shaft adapter.
Make sure that the roller shutter shaft is flush with the limit switch adapter motor head.
3.1
Safety catch
3.5
Motor head
Limit switch adapter
3.9
wrong

Mount bearings:

4
Remove old wall bearing on motor side (left or right installation possible).
Mount motor bearing at this point.
Make sure that the roller shutter motor with the shaft unit sits horizontally in the roller shutter box.

Mount motor with shaft unit:

5
Insert the motor head (with the entire shaft unit) into the motor bearing and secure it with the supplied safety pin.
>
fig. 3.3 / 3.4
>
fig. 3.5 / 3.6
3.2
Shaft adapter
3.6
3.10
right
>
fig. 3.9 / 3.10
3.3
Replace limit switch
adapter
3.7
Shutter shaft
>
fig. 3.1 / 3.2
>
fig. 3.7 / 3.8
3.4
Click
Fold
3.8
Recess
3T-MOTORS Tubular motors | Installation instructions
7