Audiopax 5 Manual - Page 5

Browse online or download pdf Manual for Amplifier Audiopax 5. Audiopax 5 10 pages.

Print Page

on/off" switch, except when it is recommended that the entire system be

turned off (such as during trips).

● After power-up, Model 5 will need 30 minutes to reach its thermal

stabilization, which will guarantee its best performance.

Some important notes:

● Bypass input does not go through volume control (it will always have

maximum gain) and it is available to allow easy integration of Model 5

into a multichannel system without the need for cabling changes. If it's not

used in this mode, we recommend the use of short circuit RCA caps in

these inputs, avoiding unwanted noise in the case of standby off or power

off. It will be switched to output in three situations:

○ Manually by the channel selection front switch.

○ Automatically when the pre is turned off, either by the front panel

"standby" switch, the power supply "on/off" switch or due power

failure shutdown (eg unplugged from the ac cable).

○ The cd player input can also be used with 3-pin (XLR) connectors

by simply switching the "unbalanced/balanced" switch on the back

panel of the preamplifier to the "balanced" position.

○ The three outputs (two RCA and one XLR) operate simultaneously

and any of them can be used.

○ 3-pin input and output (XLR) can be "pseudo-balanced" (only an

XLR cable adapter, but operating as unbalanced) or transformer

balanced, the latter being a Model 5 option.

● Both inputs and outputs follow the white/red and upper/lower conventions

for left/right channels.