Audiovox 1181277 Installation Instructions Manual - Page 3

Browse online or download pdf Installation Instructions Manual for Car Video System Audiovox 1181277. Audiovox 1181277 8 pages. Chevrolet s-10 blazer overhead console for use with flipdown video system

Print Page

FIGURE 1

2. Lower console and disconnect wiring at (2) two

locations. Lay console on workbench for

modification later.

See Figure 2.

FIGURE 3

I. PREPARATION OF VEHICLE INTERIOR

1. Remove the O.E.M. console mounted to inner

roof of vehicle. Remove and discard dome light

cover to gain access to (2) two #8 x 3/4"

screws. Retain screws. Remove and retain (1)

one #8 x 1 1/2" screw located in front of

console near rear view mirror. See Figure 1.

FIGURE 2

3. Using rear edge of opening in headliner, carefully

trim headliner as shown and install mounting

bracket (item 5 pg 2). Make sure the 8" cut is

centered in vehicle. Caution: Before cutting

headliner material, check for wiring or other

componentry above headliner. Cut only where

indicated. Secure front of bracket to roof brace

using (2) two O.E.M. screws, previously

removed, in original locations. Make sure that

bracket is centered in vehicle and secure rear of

bracket to roof brace using (4) four #8 x 3/4"

screws (item 1 pg 2). Install (2) two #8 x 3/4"

screws (item 1 pg 2) in remaining holes next to

O.E.M. screws previously installed.

See Figure 3.