Aponorm BASIS PLUS BLUETOOTH Instructions For Use Manual - Page 10

Browse online or download pdf Instructions For Use Manual for Blood Pressure Monitor Aponorm BASIS PLUS BLUETOOTH. Aponorm BASIS PLUS BLUETOOTH 19 pages.

Print Page

Range

Systolic Diasto-

blood

pressure

≥ 135

too high

blood

pressure

130 -134 80-84

elevated

blood

pressure

< 130

optimum

The higher value is the one that determines the

evaluation. Example: a blood pressure value of

140/80 mmHg or a value of 130/90 mmHg indi-

cates «blood pressure too high».

Pulse arrhythmia detector (PAD)

This symbol

indicates that certain pulse

irregularities were detected during the mea-

surement. If the result deviates from your normal

blood pressure repeat the measurement. In most

cases, this is no cause for concern. However, if the

symbol appears on a regular basis (e.g. several

times a week with measurements taken daily) we

advise you to tell your doctor.

4. Data memory

This monitor automatically stores the last 99

readings for each user.

Recommenda-

lic

tion

seek medical

≥ 85

advice

self-check

< 80

self-check

Viewing the stored values

Press the M button

briefly while the monitor

is switched off. Now the display changes over to

the data memory display, indicated by «M»

(M» = Memory). First, the average value of all

measurement stored in the memory is shown, as

indicated by the «A» to the right of the value («A»

= Average).

Pressing the M button again displays the last value

measured. Pressing the M button repeatedly allows

you to move from one stored value to another (from

the last to the first entry in the memory).



Blood pressure readings with the cuff posi-

tion and fit

-B being not optimal are not

included in the average.



Pay attention that the maximum memory

capacity of 99 values for either user is not

exceeded. When the memory is full, the oldest

value is automatically overwritten with the

100th value. The values should be evaluated

by a doctor or documented in a blood pres-

sure diary before the full memory capacity is

reached - otherwise data will be lost.