AUSTRALIAN MADE GREAT MATE Installation And Setup Instructions - Page 17

Browse online or download pdf Installation And Setup Instructions for Engine AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 pages. Double swing gate motor kit

Print Page

ENSURE THE TRANSFORMER IS SWITCHED OFF AND THE BATTERY DISCONNECTED

Refer to the "DC2 Circuit Board" data sheet included with this manual and locate the '12-24VAC'

terminals on the circuit board.

Connect the 12 v transformer wires to the '12-24VAC' terminals on the circuit board. There is no

positive or negative transformer wire and they can connect to either of the two "12-24VAC'

terminals. Connect the battery wires to the battery. Red, Positive wire to

Black / Blue Negative wire to Black battery terminal. The board should now be powered

and great care should be taken to avoid shorting out or otherwise damaging the circuit board.

Turn on the transformer, replace the metal motor cover and test.

Transformer

Feed transformer wires through the

12 v Transformer

hole in the support tray with the

Wires

battery wires

If the 12 v low voltage transformer wires need to be extended then we recommend you use a ter-

minal block / joiner. Place the terminal block / joiners into a small enclosure for protection and

outdoor installation.

12 v Low Voltage

Transformer Wires

Terminal Block

1.5mm Twin Active Low

Voltage Cable

Transformer Wiring

Instructions

Battery Wires

Battery Connection

Connect 12 v Transformer

Wires to 12-24VAC Terminals

Red

battery terminal,

Red

wire to

Red

battery

terminal

Black / Blue

wire to Black

battery terminal

Weather Proof

Enclosure