Gaggenau GI 976 760 Manual - Page 10

Browse online or download pdf Manual for Dishwasher Gaggenau GI 976 760. Gaggenau GI 976 760 14 pages.

Print Page

HOT WATER CONNECTION

THESE INSTALLATION

INSTRUCTIONS ARE

INTENDED FOR USE BY

QUALIFIED INSTALLERS

Connecting the Hot Water

Supply Line

• If using a solder joint instead of a com-

pression fitting, be sure to make all

solder connections before connecting

the water line to the dishwasher.

• Make sure there are no sharp bends or

kinks in the water line which might

restrict water flow.

• When connecting threaded pipe use pipe

thread compound or Teflon tape to seal

the connection.

• Before connecting the copper hot water

supply line to the dishwasher, it should

be flushed with hot water to clear any

foreign material.

• Apply Teflon tape or other pipe sealant

to 90° elbow fitting and connect

directly to water inlet valve (located at

the bottom front of the dishwasher)

• Turn on the water supply to check for

leaks after making connections.

Openings for water lines must be

installed in the marked areas as shown

Figures

and

interference with the dishwasher

frame or other components.

* See Figure 15 and 16-water inlet

valve and 90° elbow

(located at the bottom front left-

hand side of the Dishwasher.)

10 - ENGLISH

Figure 15

DO NOT SOLDER WITHIN 6 INCHES

(152.4 MM) OF THE DISHWASHER'S

INLET VALVE.

TEMPERATURES REQUIRED FOR

SOLDERING WILL DAMAGE THE

VALVE!

avoid

Figure 16

www.gaggenau.com/us

Shut off valve

(not included)

Water

inlet

valve

CAUTION