ADEMCO Honeywell 5806 W3 Troubleshooting Manual - Page 4
Browse online or download pdf Troubleshooting Manual for Security Sensors ADEMCO Honeywell 5806 W3. ADEMCO Honeywell 5806 W3 9 pages. Smoke & heat detector
Print Page
Smoke & Heat Detector Troubleshooting
o
Alarm (>135 ) second
Trouble
Off
Low Battery
Blinks every 50
0-7 days
seconds
Low Battery
Blinks every 50
8+ days
seconds
Blinks every 50
Tamper
seconds
https://alpha.adt.com/help/89[11/12/2018 9:58:31 PM]
In Alarm
Steady
Chirp
Trouble Signal
Off
Low Battery
Chirp
Low Battery
Off
Tamper
minutes. If necessary, silence the
alarm keypad.
Remove the source of the heat, if it
can be done safely.
A problem has been detected with
the smoke detector. The smoke
detector compensates for long term
changes in the environment
resulting from dust and other
factors. This automatic
compensation sensitivity needs to
be reset by a technician. Please
refer to the
Contact Us
The battery power is low. ADT has
been contacted. You will be notified
of the non-emergency situation.
Replace the battery. Please refer to
the
Smoke and Heat Detector
Battery Replacement
page.
The battery power has been low for
8 or more days. Press the Test
switch to silence the chirp for 12
hours. ADT has been contacted. You
will be notified of the non-
emergency situation. Replace the
battery immediately. Please refer to
the
Smoke and Heat Detector
Battery Replacement
page.
An attempt has been made to
remove the Smoke Detector, causing
the Tamper switch to be depressed.
ADT has been contacted. You will be
notified of the non-emergency
situation. Take appropriate
precautions or replace the smoke
detector properly. Note: Tamper
switch is recessed behind sensor
body; it can be seen in square
page