Hidro-Water ATHENEA Manual - Page 7

Browse online or download pdf Manual for Water Filtration Systems Hidro-Water ATHENEA. Hidro-Water ATHENEA 16 pages.

Print Page

Here is a diagram of how the ultrafiltration system should be installed.

5.- ULTRAFILTRATION SYSTEM START UP

a. Unscrew the back of the system, lift the lid

and pull out.

b. Make sure that all the connections are

connected properly and tightened.

c. Make sure that the arm of the WATER STOP

Antileak system is down like shown in the fig-

ure so that the water can enter the ultrafiltra-

tion system.

d. Open the water supply and then the ball

valve (figure 5) as shown. Make sure there

is no water leak. If there is, close the valve

and fix it.

e. Open the faucet (Figure 2) and let all of the air out from inside the ultra-

filtration system. Once a continual water flow comes out of the faucet,

let it run for 30 seconds and then close the faucet. If in the beginning,

the water runs black, don't worry, this is normal, it's caused by the resi-

due that the granulated carbon filter lets off. Drain this water. The water

will run clear not long after this.

Raise the arm on the WATER STOP An-

tileak system and place one of the pieces

of the absorbent material supplied with the

WATER STOP Antileak system. Keep the

other one safe as a spare part. Lower the

arm of the system so that water can enter

the ultrafiltration system.

ref: MA-UF-0002-EN-V14.0-ATHENEA.pdf