ADEMCO TeleCommand User Manual - Page 14

Browse online or download pdf User Manual for Control Unit ADEMCO TeleCommand. ADEMCO TeleCommand 20 pages. Telephone module

Print Page

System Status Reports (cont'd)

Arming Status

This report will indicate whether the system is armed, the arming

mode, and if armed with any bypasses, or if the system is disarmed

and whether it is ready or not ready to arm.

Annunciations when the system is in an armed state would be one of

the following:

"ARMED STAY," "ARMED AWAY," "ARMED STAY INSTANT,"

or "ARMED AWAY INSTANT."

If any bypasses are in effect, the word "BYPASS" will be added to the

armed message.

Annunciations when the system is in the disarmed state are:

"SYSTEM READY" or "SYSTEM NOT READY."*

* If the message "SYSTEM NOT READY" is heard, and the "Zone

Faults" report does not follow (see Zone Faults below), simply press

the [✱] key to hear the particular zones that are faulted.

If there is a zone fault (for example, a door or window open), the word

"FAULT" will be annunciated, followed by a zone descriptor** (for

example, "UPSTAIRS BEDROOM") and a zone number. If zone

faults are not annunciated in your system, press [✱] key to

hear zones that are faulted.

Note: Silent alarms will be annunciated.

** If programmed by your installer.

•

Certain system status messages are displayed on a keypad only, such as

Transmitter Low Battery (zone # followed by the state), Chime, and Tamper.

•

On FBII systems, TeleCommand will announce a Zone 9 low battery as

"LOW BATTERY, SYSTEM READY, ZONE 9 NOT READY"

•

On ADEMCO systems, a wireless zone low battery is announced as "ZONE

XXX LOW BATTERY," where XXX = the zone number.