Galvo Shed GVO 2315 Assembly Instructions Manual - Page 2
Browse online or download pdf Assembly Instructions Manual for Outdoor Storage Galvo Shed GVO 2315. Galvo Shed GVO 2315 8 pages. Sloping roof shed
Print Page
COMPONENTS CHECKLIST
Please check all components carefully and advise your supplier immediately if any discrepancies.
Remember to quote the code on the front page.
1 x 1920 x 780mm door sheet
A
3 x 1830mm x 780mm sheets (roof)
D
4 x 1485mm 'U' channels for end walls
G
(2 per side)
2 x 780mm 'U' channels (door top and bottom)
J
1 x 310mm door plate
M
IMPORTANT!
• Remove the swarf (drill filings) from the panels as you assemble them.
• All components are cut to length. Do not cut any parts unless instructed.
• Fixings through the inside of the channels into the sheeting are just as important as
fixings from the outside.
RIBS AND PANS
• Generally most fixings are spaced at 300mm apart.
• Keep the fixings in the pans as close to the ribs as possible for added strength.
• Ribs will always protrude to the outside of the shed.
• Extra internal fixings are strongly recommended in high wind areas.
• Panel sizes may vary by up to 10mm.
BUILDING YOUR SHED
• The basic task is to join the sheets together to
form your panels, and fix channels to the top
and bottom of these panels. They will then join
together to form your shed (diagram 1, 2, and 3).
2
2 x 1980 x
*
740mm sheets (Beside door front)
B
4 x 1980mm - 1830mm sloping sheets
E
(side walls 2 left, 2 right)
2 x 1920mm 'U' channels for door sides
H
2 x 1830mm 'L' flashings
K
1 x pack screws with padbolt
N
1 x pack of rivets and hinges
DIAGRAM 1
1
C
*sheet sizes may
be a width of 700mm
or 780mm due to colour choice.
F
I
L
O
DIAGRAM 2
If you choose to vary from these instructions your warranty will be impaired
3 x 1830 x 780mm sheets (back wall)
6 x 2255mm 'U' channels for front,
back and roof
2 x 793mm 'U' channels (door spacers)
2 x 1980mm 'Z' door jambs (front)
2 x 'Z' Door braces
PAN
DIAGRAM 3
RIB