Majacraft Aura Instructions Manual - Page 7

Browse online or download pdf Instructions Manual for Spinning Wheels Majacraft Aura. Majacraft Aura 16 pages.

Print Page

Slide the flyer drive pulley onto the flyer shaft and align

the threaded hole over the flat ground on the shaft.

Screw the short grub screw into the threaded hole with

your 2mm allen key and secure the pulley to the head.

Tighten the grub screw firmly. Failing to line the grub

screw up with the flat on the shaft will cause the pulley

to slip on the shaft producing issues with take up of the

yarn when spinning.

6. Spinning Head

Required:

1 M6 45mm (1 3/4") Silver countersink bolt (in the hardware bag)

4mm allen T wrench (in the hardware bag)

1 Large SIlver aluminium handle washer (in the hardware bag)

Spinning Head

1 M6 Wooden Adjuster Screw (in the hardware bag)

Place the spinning head behind the upright with the flyer shaft facing to the front and the white nylon

guides on the head located inside the handle slot. Slide the coujntersink bolt and washer through the slot in

the handle and tighten it carefully. You can read the additional instructions at the end of this document for

information on setting the bobbin drive band tension.

The spinning head can be raised or lowered to suit the tensioning of

the drive belts and the height you wish to spin at. The recommended

approximate position is the silver bolt positioned half way up the slot.

The 6mm wooden adjuster

screw can be screwed

into the end of the hinged

adjuster block now.

majacraft