Airflow Ceiling fans Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Fan Airflow Ceiling fans. Airflow Ceiling fans 12 pages. Builder’s choice gallery edition

Print Page

3-SPEED

CONTROL FEATURES: 3-SPEED OPERATION

Pull-chain switches on the fan control the fan and lights.

Using the fan control pull-chain switch: Fan off at start.

• First pull: fan ON, high speed

• Second pull: medium speed

• Third pull: low speed

• Fourth pull: fan OFF

Using the light pull-chain switch: Light off at start.

• First pull: light ON

• Second pull: light OFF

Direction of blade rotation is controlled by the reverse slide

switch on the side of the switch housing.

No changes in household wiring are required.

Please follow this troubleshooting guide before contacting your dealer for assistance.

Caring for Finishes: For cleaning, a soft brush or lint-free cloth

should be used to prevent scratching the finish. A vacuum cleaner

brush nozzle can remove heavier dust. Surface smudges or an accu-

mulation of dirt and dust can easily be removed by using a mild

detergent and slightly dampened soft cloth. An antistatic agent

may be used, but never use abrasive cleaning agents. These will

damage the finish. Painted and high-gloss blades may be cleaned

in the same manner.

Blades: Wood finish blades should be cleaned with a furniture pol-

ishing cloth. Occasionally, a light coat of furniture polish may be

applied for added protection and beauty.

Possible Remedies

Problem

FAN WILL NOT START

Check main circuit fuses, circuit breakers, or wall switch position.

Check all wire connections, making sure the power is turned off during this inspection.

Check that reverse switch is not set in center of throw.

FAN WOBBLES OR SHAKES

Be sure mounting bracket pin is properly set into the slot on the ball.

EXCESSIVELY

Check the screws holding the blade holders to the motor. Tighten as necessary.

Check that bladeholders have not been bent during installation.

FAN NOISY DURING

Check and tighten light fixture retaining screws, glass shade screws and/or the light bulb(s) as neccessary.

OPERATION

Tighten the blade to bladeholder screws.

Tighten canopy screws and mounting plate assembly.

Check and tighten blade holders to motor.

Make sure all screws in the motor housing are snug but not overly tight.

Check that the wire nuts inside the canopy and switch housing are not touching the metal parts or have

fallen off the wire splices. Tighten or adjust as necessary.

BREAK-IN PERIOD

Let fan run at high speed for two hours.

DOES NOT RUN ON

If new, "break-in" may be required. Run at higher speed for several days.

LOW SPEED

For questions or to locate the nearest Airflow Authorized Service Center, call toll free:

LIGHT

PULL CHAIN

SWITCH

TROUBLESHOOTING

BEFORE REQUESTING SERVICE:

Never Lubricate This Fan!

The precision motor at the heart of your Airflow fan features sealed

bearings that are lubricated for life. Do not attempt to oil the motor.

Changing Lightbulbs

Be sure to turn power to the fan OFF at the wall switch or circuit

breaker before changing lightbulbs. Replace bulbs with same type

as removed from the fixture. Each fan is rated for a maximum TOTAL

wattage of lighting. Exceeding the rated maximum allowable watt-

age for the fan will burn out the fan electronics module and void

the warranty.

1-888-227-2178

FAN & SPEED

CONTROL

PULL CHAIN SWITCH

REVERSE

SWITCH