IKEA NUTID Installation And User Instructions Manual - Page 20

Browse online or download pdf Installation And User Instructions Manual for Oven IKEA NUTID. IKEA NUTID 46 pages. French door refrigerator
Also for IKEA NUTID: Installation Manual (16 pages), Installation Manual (12 pages), Assembly Instructions Manual (12 pages)

Print Page

IKEA NUTID Installation And User Instructions Manual

System tested and certiﬁed by NSF International against NSF/ANSI Standard 42 for the reduction of

Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of

Lead, Mercury, Atrazine, Benzene, p-Dichlorobenzene, Carbofuran, Toxaphene, Cysts, Turbidity,

Asbestos, O-Dichlorobenzene, Ethylbenzene, Chlorobenzene, Endrin, Tetrachloroethylene and Lindane.

This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The

concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the

permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.

Substance Reduction

NSF Reduction

Aesthetic Effects

Requirements

Chlorine Taste/Odor

50% reduction

Particulate Class I*

85% reduction

Contaminant

NSF Reduction

Reduction

Requirements

Lead: @ pH 6.5

0.010 mg/L

Lead: @ pH 8.5

0.010 mg/L

Mercury: @ pH 6.5

0.002 mg/L

Mercury: @ pH 8.5

0.002 mg/L

Benzene

0.005 mg/L

p-Dichlorobenzene

0.075 mg/L

Carbofuran

0.040 mg/L

Toxaphene

0.003 mg/L

Atrazine

0.003 mg/L

Asbestos

>99%

Live Cysts‡

>99.95%

Turbidity

0.5 NTU

Lindane

0.0002 mg/L

Tetrachloroethylene

0.005 mg/L

O-Dichlorobenzene

0.6 mg/L

Ethylbenzene

0.7 mg/L

Chlorobenzene

0.1 mg/L

Endrin

0.002 mg/L

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.55 gpm (2.08 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F

± 5°F (20°C ± 3°C).

It is essential that operational, maintenance, and filter

■

replacement requirements be carried out for the product to

perform as advertised.

The disposable water filter should be replaced at least every

■

6 months.

The filter monitor system measures the amount of water that

■

passes through the filter and alerts you to replace the filter.

When 90% of the filter's rated life is used, the yellow (Order)

light comes on. When 100% of the filter's rated life is used,

the red (Replace) light comes on, and it is recommended

that you replace the filter. For models without filter status

lights, replace the filter every 6 months. Use replacement

filter model UKF8001AXX-200. 2011 suggested retail price

of $44.99 U.S.A./$49.95 Canada. Prices are subject to

change without notice.

The product is for cold water use only.

■

Do not use with water that is microbiologically unsafe or of

■

unknown quality without adequate disinfection before or

after the system. Systems certified for cyst reduction may

be usedon disinfected waters that may contain filterable

cysts.Refer to the "Water Filtration System" section for the

Manufacturer's name and telephone number.

* Class I particle size: >0.5 to <1 um

** Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.

† These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.

†† Fibers greater than 10 um in length

‡Based on the use of Cryptosporidium parvum oocysts

NSF is a trademark of NSF International.

Interior Water Filtration System

Model UKF8001AXX-200 Capacity 200 Gallons (757 Liters)

Average

Influent Challenge

Influent

Concentration

2.00 mg/L

2.0 mg/L ± 10%

14,000,000

At least 10,000

#/mL

particles/mL

Average

Influent Challenge

Influent

Concentration

0.150 mg/L

0.15 mg/L ± 10%

†

0.150 mg/L

0.15 mg/L ± 10%

†

0.006 mg/L

0.006 mg/L ± 10%

0.0059 mg/L

0.006 mg/L ± 10%

0.0133 mg/L

0.015 mg/L ± 10%

0.210 mg/L

0.225 mg/L ± 10%

0.0753 mg/L

0.08 mg/L ± 10%

0.015 mg/L

0.015 ± 10%

0.0102 mg/L

0.009 mg/L ± 10%

126.5 MF/L

122,500 #/L

50,000/L min.

10.5 NTU

11 ± 1 NTU

0.0019 mg/L

0.002 ± 10%

0.015 mg/L

0.015 mg/L ± 10%

1.7 mg/L

1.8 mg/L ± 10%

2.2 mg/L

2.1 mg/L ± 10%

2.0 mg/L

2.0 mg/L ± 10%

0.007 mg/L

0.006 mg/L ± 10%

Maximum

Effluent

0.06 mg/L

370,000 #/mL**

Maximum

Effluent

< 0.001 mg/L

0.0005 mg/L

0.0018 mg/L

0.0005 mg/L

< 0.0005 mg/L

0.027 mg/L

< 0.001 mg/L

0.0027 mg/Lq

to 10

fibers/L

< 0.17 MF/L

††

< 1 #/L

‡

0.30 NTU

< 0.00016 mg/L

< 0.0005 mg/L

< 0.5 mg/L

0.0048 mg/L

0.0038 mg/L

0.0004 mg/L

Refer to the "Warranty" section for the Manufacturer's

■

limited warranty.

Application Guidelines/Water Supply Parameters

Water Supply

Water Pressure

Water Temperature

Service Flow Rate

Average

Minimum%

Effluent

Reduction

0.050625 mg/L

97.00%

196,666 #/mL

97.40%

Average

Minimum%

Effluent

Reduction

< 0.001 mg/L

>99.30%

< 0.001 mg/L

>99.30%

0.0003 mg/L

91.70%

0.00073 mg/L

69.20%

0.0005 mg/L

96.10%

< 0.0005 mg/L

>99.80%

0.008 mg/L

64.60%

< 0.001 mg/L

>93.3%

0.00105 mg/L

76.30%

< 0.17 MF/L

>99.99%

< 1 #/L

>99.99%

‡

0.125 NTU

97.30%

0.000035 mg/L

91.80%

< 0.0005 mg/L

>96.6%

< 0.5 mg/L

>99.9%

0.11 mg/L

99.80%

0.0008 mg/L

99.80%

0.0002 mg/L

94.30%

City or Well

35 - 120 psi (241 - 827 kPa)

33° - 100°F (1° - 38°C)

0.55 gpm (2.08 L/min.) @ 60 psi

Average%

Reduction

97.52%

99.00%

Average%

Reduction

>99.30%

95.00%

88.10%

96.30%

>99.80%

73.45%

>93.3%

89.40%

>99.99%

98.80%

97.90%

>96.6%

>99.9%

99.90%

96.80%